Solving Problems With The Remote Control - Epson PowerLite 61p User Manual

Solving Problems with the Remote
Control
The projector doesn't respond to remote control commands.
Make sure you are within 20 feet of the projector, and within
range of the projector's front or back sensor (approximately 30° to
the left or right and 15° above or below).
The remote control batteries may not be installed correctly or may
be low on power. Replace the batteries as described on page 48.
Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector's infrared
receivers.
Turn off any nearby equipment that emits infrared energy, such
as a radiant room heater.
You have lost the remote control.
You need the remote control to access many projector features. If you
have lost it, you can order another from Epson. See page 92 for details
about ordering.
You can't control the mouse pointer with the remote
control.
Make sure the USB mouse cable is securely connected to both
your computer's USB port and the projector's USB port. For
details, see page 19.
Make sure
RS232C
Extended menu. See page 60.
To use the USB mouse connection on a PC, your system must
have a "clean" installation of Windows 98, Windows Me,
Windows XP, or Windows 2000. The connection may not work
correctly if your system was upgraded from Windows 95.
is selected as the COM Port setting in the
Solving Problems
91