Advertisement
4.
5.
Move the On/Auto/Off
lever to
"ON/AUTO"
position. The
compressor will start.
Run the compressor for 15
minutes, Make sure the drain
valve is open and there is
minimal air pressure build-up in
tank,
After 15 minutes, close the drain
valve (clockwise), The air receiver
will fill to "cut-out"
pressure and
the motor will stop,
The compressor is now ready for use.
Before
Each Start-Up:
2.
li Place
On/Auto/Off
lever to
2i
Pull regulator knob eu_, turn
eountercleckwis8
unti! it stePS;
Push knob in to lock in place,
3:
Attach hose and accessories:
Tee much air
pressure
Causes a
hazardous risk of bursting. Check
the manufacturer's
maximum
pressure rating for air tools end
accessories.
The regulator outlet
pressure must never exceed the
maximum
pressure rating.
How to Start:
1.
Turn the On/Auto/Off
lever to
"AUTO" and allow tank pressure
to build.
Motor will stop when
tank pressure reaches "cut-out"
pressure,
Pull the regulator knob out and
turn clockwise to increase
pressure, When the desired
pressure is reached push knob in
to lock in place. The compressor
is ready for use.
NOTE: Always operate the air
compressor
in well-ventilated
areas
NOTE: ii-_e hose Or aceess0ry
free of gesoline or other combustible
Will requite a quick connect plug
vapors. If the compreesor
is being
if the air Outlet is equipped
with a
used to operate a sprayer DO NOT
quibk connect,
place near the spray area,
15- ENG
D27304
Advertisement
