Operation; Controls Description; Fueling Engine - Craftsman 358.797931 Operator's Manual

KNOW YOUR BLOWER
READ THIS OPERATOR'S MANUAL AND SAFETY" RULES BEFORE
OPERATING YOUR UNIT_ Compare the illustrations with your unit to familiarize
yourself with the location of the various controls and adjustments° Save this
manual for future reference.
_.fSpark Run Speed Control (_) ON[STOP
Primer-- I _wltcn
Bu.oo ®
,,/....
__. [),t_'><j Fuel M ix
_ "_ _ "- \ Fill Cap
I )l Tubo Starter
K'3 VaouumTube "---_ \
v ,, . __
-
"_--'==J_- Rear
ON/STOP SWITCH
The ON/STOP switch is used to stop
the engine° The switch stays in the ON
position. To stop engine, push and hold
the switch in the STOP position until
the engine comes to a complete stop.
COLD START
The Cold Start (_ helps to supply fuel
to the carburetor during starting° This
allows you to start a cold engine° Acti-
vate the Cold Start (_ by moving the
Cold Start C) lever to the Start position.
After engine has started, move Cold
Start (_ lever to the Run position. See
,11,,, i,,, i, ,i ,111 ,,i,,11,,, ,11,11
__Eye Protection---_
Blower Vacuum
BEFORE STARTING ENGINE
WARNING: Be sure to read the fuel
information in the safety rules before
you begin. If you do not understand the
the Starting Your Engine section for
complete starting information.
PRIMER BUTTON Q
The Primer Button (_) removes air from
the fuel lines and fills them with fuel
This allows you to start the engine with
fewer pulls on the starter rope. Activate
Primer Button (_) by pressing it and al-
lowing it to return to its original position.
SPEED CONTROL (_)
The Speed Control (_ controls engine
speed. Move it all the way forward for full
speed operation. Move it all the way
rearward for idle speed.
ii ........................
safety rules, do not attempt to fuel your
unit. Call 1-800-235-5878=
FUELING ENGINE
This engine is certified to operate on
unleaded gasoline, Before operation,
gasoline must be mixed with a good
quality 2-cycle air-cooled engine oil.
We recommend Craftsman brand oil.
Mix gasoline and oil at a ratio of 40:!
(A 40:1 ratio is obtained by mixing 3.2
ounces of oil with 1 gallon of unleaded
gasoline). DO NOT USE automotive oil
or boat oil. These oils will cause engine
damage. When mixing fuel, follow
instructions printed on container.
Once oil is added to gasoline, shake
container momentarily to assure that
-6-