Jenn-Air JGW8130DDB Use & Care Manual page 19

T
ROUBLESHOOTING
PROBLEM
Oven door will not unlock.
Baking results are not as
expected or differ from
previous oven.
Fan is heard during broiling,
cleaning and some baking
operations.
Cooling fan continues to
operate after the oven has been
turned off.
Fault Codes
There are no beeps and
no display.
Noises may be heard.
SOLUTION
• Oven may not have cooled to safe temperature after self-cleaning process.
• The control and door may be locked. See page 5.
• Check the oven temperature selected. Make sure oven is preheated when recipe
or directions recommend preheat.
• Make sure the oven vent has not been blocked. See page 10 for location.
• Temperatures often vary between a new oven and an old one. As ovens age, the oven
temperature often "drifts" and may become hotter or cooler. See page 10 for
instructions on adjusting the oven temperature. Note: It is not recommended to
adjust the temperature if only one or two recipes are in question.
• Use correct pan. Dark pans produce dark browning. Shiny pans produce light
browning.
• Check rack positions and pan placement. Stagger pans when using two racks. Allow
1-2 inches between pans and oven wall.
• Check the use of foil in the oven. Never use foil to cover an entire oven rack. Place
a small piece of foil on the rack below the pan to catch spillovers.
• This is the cooling fan and is normal. The fan will continue to run after use
until the oven cools.
• This is normal. The fan will automatically shut off when the oven has cooled.
• BAKE or LOCK may flash rapidly in the display to alert you if there is an error
or a problem. If BAKE or LOCK appear in the display, press CANCEL pad.
If BAKE or LOCK continue to flash, disconnect power to the appliance.
Wait a few minutes, and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized servicer.
• If the oven is heavily soiled, excessive flareups may result in a fault code during
cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out
excess soil, then reset the clean cycle. If the fault code reappears, contact an
authorized servicer.
• Oven may be in Sabbath Mode. See page 9 .
• The oven makes several low level noises. You may hear the oven cooling fan going
on and off. You may also hear the oven relays as they go on and off. These are all
normal.
• As the oven heats and cools, you may hear sounds of metal parts expanding and
contracting. This is normal and will not damage your appliance.
18