Solving Picture And Sound Problems - Epson MOVIEMATE 72 User Manual

■
Check the
See page 48.
■
The Screensaver feature turns off the picture if a still image is projected for more than 15
minutes. See page 40.
■
If you're using external video equipment, check the solutions on page 58.
The DVD skips.
■
Make sure Epson MovieMate is not tilted more than 15 degrees while playing CDs or
DVDs. This can cause skipping or disc scratches. Use the vertical image adjustment dial
to adjust the image position. See page 15.
■
Make sure there are no fingerprints or scratches on the DVD.
The remote control doesn't work.
■
Make sure the toggle switch is in the correct position: set to
buttons, or to
■
Make sure you're within 23 feet (7 meters) of Epson MovieMate, and within range of its
front or back sensor (approximately 30° left or right, and 15° above or below).
■
You may need to replace the remote control's batteries. Make sure they're inserted with
the positive (+) and negative (–) ends positioned as shown in the battery compartment.
■
Some discs don't support all of the remote control's functions.
■
If you're using a "universal" remote control, it might not work with Epson MovieMate.
Epson does not support any third-party remote controls.

Solving Picture and Sound Problems

The picture is blurry or out of focus.
■
Adjust the focus using the focus ring. See page 15 for instructions.
■
There may be dirt on the lens. Clean the lens as described on page 45.
■
Make sure the lens is not fogged by condensation. If you've just moved Epson
MovieMate from a cold environment, wait approximately an hour before using it. If
condensation forms, unplug Epson MovieMate and wait an hour or two before use.
■
Make sure Epson MovieMate is placed the correct distance from the screen: no closer
than 2.4 feet (0.72 meters) and no farther than 49.4 feet (13.66 meters).
56
Problem Solving
warning light. If it is flashing orange or red, you need to replace the lamp.
to use the other functions of these buttons.
Func.-
to use the numeric
-123