Epson MOVIEMATE 72 User Manual page 59

You see the message
■
Make sure the equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 23).
■
Press the button on Epson MovieMate or the remote control to select the external
video source. Allow a few seconds for Epson MovieMate to sync up.
You see the message
Press the button on the remote control and check the
page 43).
The picture is cut off (too large) or too small.
Press the button on the remote control and select the appropriate aspect ratio.
Press the button on the remote control and select the appropriate zoom setting.
The picture is distorted.
■
If you're using an extension cable, electrical interference may affect the signal.
■
Check the solutions on pages 56 and 57.
The colors are not right.
■
Press the button on the remote control and check the
page 43).
■
Press the button on the remote control to select the best setting for your viewing
environment.
■
Adjust the
Color Saturation
.
No Signal
Signal not supported.
or settings. See page 41.
Tint
setting (see
Video Signal
setting (see
Video Signal
Problem Solving
59