Craftsman 146.669950 Owner's Manual page 3

RULES FOR SAFE OPERA TION (Continued)
12. DON'T ABUSE CORD. Never carry tool by cord or yank it to disconnect from re-
ceptacle. Keep cord from heat, oil and sharp edges.
13. SECURE WORK. Use clamps or avise to hold work. It's safer than using your hand
and it frees both hands to operate tool.
14. DON'T OVERREACH. Keep proper footing and balance at all times.
15. MAINTAIN TOOLS WITH CARE. Keep tools sharp at all times, and clean for best
and safest performance. Follow instructions for lubricating and changing acces-
sories.
16. DISCONNECT TOOLS when not in use or before servicing.
17. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see
that keys and adjusting wrenches are removed from tool before turning it on.
18. AVOID ACClDENTALSTARTING. Don't carry plugged-in toolswith fingeron switch.
Be sure switch is off when plugging in.
19. NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor
could ignite fumes.
20. INSPECT TOOL CORDS PERIODICALLY and if damaged, have repaired at your
nearest Sears Repair Center.
21. INSPECT EXTENSION CORDS PERIODICALLY and replace if damaged.
22. KEEP TOOLS DRY, CLEAN, AND FREE FROM OILAND GREASE. Always use a
clean cloth when cleaning. Never use brake fluid, gasoline, or any strong solvents to
clean yot_r tool.
23. STAY ALERT. Watch what you are doing and use common sense. Do not operate
tool when you are tired.
24. CHECK DAMAGED PARTS. Before further use of the tool, aguard or other part that
is damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding of
moving parts, breakage of parts, mounting, and any other conditions that may affect
its operation. A guard or other part that is damaged should be properly repaired or
replaced by an authorized service center unless indicated elsewhere in this instruc-
tion manual.
25. DO NOT USE TOOL IF SWITCH DOESNOTTURN IT ON AND OFF. Have defective
switches replaced by authorized service center.
26. N EVER LEAVE TOOL RUNNING UNATTENDED. TURN POWER OFF. Don't leave
tool until it comes to a complete stop.
27. REPLACE CRACKED WHEEL IMMEDIATELY.
28. WHEN SERVICING USE ONLY IDENTICAL REPLACEMENT PARTS.
29. THIS TOOL IS INTENDED FOR RESIDENTIAL USE ONLY.
30. MAKE WORKSHOP KID PROOF with padlocks, master switches, or by removing
starting keys.
31. ADJUST DISTANCE BETWEEN WHEEL & TOOL REST. Maintain 1/16" or less
clearance as the diameter of the wheel decreases with use.
32. SAVE THESE INSTRUCTIONS.
The operation of the Wet Sharp Machine can result in foreign objects being thrown
into the eyes, which can result in severe eye damage. Always wear safety glasses or
eye shields before commencing power tool operation. We recommend Wide Vision
Safety Mask for use over spectacles or standard safety glasses, available at Sears
Catalog Order or Retail Stores.
3