Craftsman 320.28191 Product Manual page 18

USUNG THE LASER TRAC
TM
LASER GUIDE (Fig. 6)
,_ WARNING: !_ASER
LIGHT, LASER RADIATION.
Avoid Direct Eye Exposure, DO
NOT stare into beam. Only turn
laser beam on when the saw
is on the workpiece, The laser
is factory installed and aligned,
Class !lla laser.
To operate the laser guide:
1.
I Fig. 6
Laser Switch
Disconnect the saw from
the power source.
2. Mark the line to be cut on the workpiece_
3o Adjust the depth and angle of the cut as needed.
4. Plug the saw into an electrical outlet.
5. Slide the Laser switch forward to turn the laser on.
6. Start the saw.
7, Align the laser beam with the cut line, and slowly push the saw forward into the
workpiece.
& Once the cut is complete, release the trigger switch, and allow the saw to come
to a complete stop.
9. Always turn laser beam off when you have finished cutting.
NOTE: Do not touch the blade to the workpiece until the saw has reached maxi-
mum speed
NOTE: Make a trial cut on a piece of scrap material to ensure that the laser is
aligned properly.
USING THE LED WORKLeGHT
The saw is equipped with a fixed-position worklight for better visibility when cutting_
It will be lighted for illuminating the cutting area as soon as you plug in the saw.
28191 ManuaLRevised 07-0202 Page 18