Craftsman 320.28191 Product Manual page 9

1_ Keep guards in place and in working order,
2. Avoid accidental starting. Be sure the switch is in the "Off" position before
plugging the tool into an electrical outlet.
3. Do not carry tools with your finger on the switch.
4_
Use clamps or another practical way to secure and support the workpiece
to a stable platform. Holding the work by hand or against your body leaves it
unstable and may lead to loss of control.
54
6_
Do not over reach. Keep proper footing and balance at al! times_
Do not force the tool. Use the correct tool and blade for your application. The
correct tool and blade will do the job better and more safely when used at the
rate for which it is designed_
7. Do not use tool if the switch does not turn it "ON" or "OFF," Any toot that
cannot be controlled with the switch is dangerous and must be repaired.
8. Disconnect the plug from the power source and/or the batter pack from
the power tool before making any adjustments, changing accessories or
storing power tools. Such preventive safety measures reduce the risk of starting
the power tool accidentally.
9. Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
10o Do not allow persons unfamiliar with the power tool or these instructions
to operate this tool.
11o Never leave the tool r_Jnning unattended; turn the power off. Don't leave the
tool until it comes to a complete stop.
12. Always maintain tools with care. Keep cutting tools sharp and clean° Properly
maintained tools with sharp cutting edges are less likely to bind and are easier to
control° Follow all instructions for lubricating and changing accessories,
13. Check for damaged parts. Before further use of the tool, a guard or other part
that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function° Check for alignment of moving
parts, binding of moving parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is damaged should be properly
repaired or replaced.
!4. Use recommended accessories. Consult the product manual for recom-
mended accessories. The use of improper accessories may increase the
risk of personal injury.
15. Use the saw, blades, etc. in accordance with these instructions and in the
manner intended for the saw, as described in this manual, taking into account
the working conditions and the nature of the work to be performed.
28191 ManuaLRevised 0743202 Page 9