Setting The Dip Switches - Epson TM-U200 Operator's Manual

Note:
Be sure to install the ribbon cassette and the paper roll before
you run the self test.
1. To perform the self test, hold down the FEED button while you
turn on the printer with the power switch.
2. The printer prints the current printer settings, and then the
PAPER OUT light blinks to indicate that the printer is in the test
printing standby state.
3. Press the FEED button to start the second part of the test, in
which the printer prints a pattern using the built-in character
set.
4. After the printer completes a certain number of lines, it prints
the following:
Then it enters the normal mode.
Note:
If you want to pause the self test manually, press the FEED
button. Press the FEED button again to continue the self test.

Setting the DIP Switches

CAUTION:
Turn off the printer while removing the DIP switch cover to
prevent an electrical short, which can damage the printer.
You can change your serial interface and print column settings by
changing the DIP switch settings.
1. Make sure the printer is off.
*** completed ***
Setting Up the Printer 1–21