Assembly Steps - Craftsman 113.196120 Owner's Manual

,_, WARNING
Plugging in saw during assembly
could result in electrical shock, or
severe cuts from contact with spin-
ning blade.
Do not plug in saw at any time dur-
ing assembly.
Plug in saw only when it is to be
used.
Assembly Steps
It is important for your safety and to get
accurate cuts that you put the saw together
according to these instructions.
Follow these steps in order.
Assembling steel legs
Note: Steel Legs are furnished with Models
113.196320 and 113.196420 (Not 113.196120).
From among the loose parts, fred the follow-
ing Hardware:
40 Truss Head Screws, 1/4-20 x 5/8
40 Lockwashers, 1/4-External
40 Hex Nuts, 1/4-20
8 Hex Nuts, 3/8 - 16
4 Leveling Feet
1. Assemble a right stiffener to a left stiffen-
er using four (4) each 1/4-20 x 5/8 long truss
head screws, lockwashers and hex nuts.
Make two assemblies of the 17-3/4" length
and the 21-1/4" length.
2. Attach the stiffener assemblies to the legs
using three (3) screws, lockwashers, and
nuts at each end. Use the holes shown with
an "X". "tighten all'nuts securely.
3. Install one 3/8-16 hex nut completely onto
each of the leveling feet. Insert one leveling
foot through hole in bottom of each leg and
install a 3/8-16 hex nut.
4. To level steel legs, loosen nut on inside of
leg and turn nut on outside to raise or lower
feet. Adjust all four levelers if necessary, and
then tighten nuts on inside of leg.
Note: These levelers are not intended for
height adjustment.
Assembly
For model 113.196420 only
From among the loose parts, fred the follow-
ing hardware:
16 Truss Head Screws 1/4-20 x 5/8
16 Lockwashers, 1/4" external
16 Hex Nuts, 1/4 -20
1. Attach the lower leg stifeners to the steel
legs using two (2) screws, lockwasher and
hex nuts on each end. For the short side of
stand, use the inside holes in the stiffeners.
For the long side, use the outside holes.
2. Tighten all nuts securely.
Stiffener Stiffener
L.H. R.H.
:!:i°:lo
L.H. Stiffener R.H. Stiffener
\ l
[ ; :1
o oo _ o_ I oo
oo o _ o_ o o
.8
t___ 2,-lJ4" ..._l
i-- --z
X = Location of Truss Head Screws
o
• ¢# C
|o
15