Craftsman 113.196120 Owner's Manual page 23

Adjustments
2. Loosen (2) 1/4 - 20 Gib socket cap screws
on the left side at the rear of the column sup-
port slightly (1/2 turn).
3. Elevate, and then lower the Arm:
a. If the column tube binds and elevation
is difficult, loosen two 5/16 - 18 plated
bolts on front side of the column support
until you achieve smooth but firm eleva-
tion.
b. If the column tube moves side-to-side
within the column support, tighten the
two 5/16 - 18 plated bolts until movement
disappears - elevation should be smooth
and firm.
4. Now tighten the (2) 1/4 - 20 Gib socket
cap screws until no noticeable rotational
play exists between Column Tube and
Column Support as shown in step 1.
5. Turn the elevation handwheel to raise and
lower the saw. If movement is too difficult
slightly loosen the socket cap screws.
Hex "L" Wrench ,j_
T"-_ I ] I
Front
Bright Plated
Loosen
° I-
_1
' I
23