Craftsman 113.196120 Owner's Manual page 17

Assembly
Attaching Carriage - Motor to Arm
Remove carriage stop screw, lockwasher and
tag. Read and understand warning tag before
discarding.
Lock miter/arm lock before proceeding.
Holding carriage assembly with both hands,
carefully start and slide the carriage onto the
tracks. The assembly must be held parallel
with the ann so that all four bearings slide
smoothly onto the arm, preventing any
excessive swain on bearings and track.
,_WARNING
Reinstall carriage stop screw and
Iockwasher to prevent carriage from
rolling off arm.
Remove two (2) motor packing studs that
are threaded into bottom of motor.
_I"_ _.. _Warning
_Loc_sher
.,_..__ Stop Screw
_ _"-- Hex "L" Wrench
(Supplied)
Push toward rear of
saw to lock Miter/Arm
Lever
Install arm cap and arm cap trim
_h.WARNING
Make certain power cord is
unplugged.
1. Insert finger under left end of switch lever
and pull out to the "ON" position.
2. Place arm cap in position and install with
(2) 10-32 x 7/8 self threading screws.
3. Push switch to "OFF" position.
ArmCap Screw
17