Craftsman 113.225941 Owner's Manual page 12

Assembly (continued) .... .- . -..
5_ Place V_belt over machine pulley and insert the V-belt
into the _open end of the guard and out the round
.::: :opening:i _:
Make_sUr@:belt has not slipped off machine pul!ey from
step 3. ?Disc and: Dust Trap Installation".
6: L0cate and instatlthree clips on the guard as shown.
GUARD
BELT
7. Place the belt onto the motor pulley by rotating the
pu!tey.
8_ Move the motor sideways so that the belt is in the
center of the opening in the top of the base. Visualty
tine up the pulleys and V-belt
9. Wedge "L" bracket under upper leg of motor base
(approximately 1/8_'):while positioning guard support
bracket around the shaft.
10. Push downward on motor to apply tension to belt and
tighten motor bolt nuts.
11 Check guard support before tightening guard support
screws. Guard support must be centered on motor
shaft. Tighten screws
12. Push guard into position on guard support.
/
/
I
t
\
BELT MUST BE ON
MACHINE PULLEY
LL ' L_ I I I
On-OFF Switch
WARNING: Don't connect power cord to electrical
outlet in your shop until you are sure motor rota-
tion is correct. See "Check Motor Rotation" sec-
tion.
The On-Off switch has a locking feature. This feature is
intended to prevent unauthorized and possible hazard-
ous use by children and others.
1. Insert key into switch. _-_
NOTE: Key is made of yellow plastic.
KEY
i¸ : i <: :
• •• 12