Craftsman 113.225941 Owner's Manual page 10

3. Find four flat head machine screw 1-3/4" long from
among the loose parts.
I_ 1 3t4
FLAT HEAD SCREWS
1 3t4" LONG
DISC DUST TRAP
_j ii ii
4. Attach t_hedisc dust trap with four flat head screws 1-
3/4" long.
5. There is a flat spot on the shaft near the end_ Rotate
the shaft so that the flat spot is facing up.
i 11 i _l,,i
6. Place the disc on the shaft so that the set screw is
facing up. Position the disc so that it is approx. 1/t6"
outward from the edge of the dust trap.
7. Insert the long end of the 5/32" setscrew wrench
through the hole in the disc housing and into the set
screw in the disc. Make sure set screw is aligned with
"flat" on shaft.
NOTE: After several hours of operation, check for
looseness of set screw and retighten,
8. Make certain that the metal disc is free of oil and
grease then peet the backing from the 9" abrasive
disc and affix to the sanding disc,
_:_ i _, '_ • "
=_ •
• . _ = _ _
DUST
TRAP
SANDING DISC
/
5132 INCH
WRENCH
10