Craftsman 113.225941 Owner's Manual page 11

9. Remove t hetopleft hand screwthatyouinstalled in
step6 andloosen theotherfourscrews.
10.Installthe dusttrap coverand replace the top left-
hand screw. T ighten allfivescrews.
TOP RIGHT HAND SCREW
DUST TRAP COVER
Installing Motor, V-Belt and Belt Guard
1. Locate the following parts:
Qty. Description
1 Motor
1 "L" Bracket
1 Pulley (approx. 2" dia.)
t V-Belt
4 Carriage bolt, 5/16-18 x 3/4
4 Flat Washer, 5/16 I.D.
4 Lockwasher, 5/16 I.D.
4 Hex Nut, 5/16-18
1 Guard Assembly including
Guard Support
Guard Support Bracket
Self-threading Screws
Clips
2. P]ace motor against the motor mounting bracket and
insert bolts through holes in motor base and then
through holes marked "X" in motor mounting bracket.
Do not tighten bolts at this time, The "L" bracket,
which holds the guard support, must be slid between
the motor base and the motor mounting bracket. The
motor must be loosely assembled to the bracket at
this time.
LOCKWASHER
FLAT WASHER
3. Slide long leg of "L" bracket between motor base and
motor mounting bracket. Then sandwich the "L"
bracket between the guard support bracket and the
guard support and fasten together with self-threading
screws as shown.
4. Install the 2" pulley onto the motor shaft flush with the
end of the shaft and tighten the set screw in the pul-
ley hub with a 5/32" hex "L" wrench. Tighten against
the flat part of the motor shaft.
MOTOR t
BASE
"'L'"
TWO HOLES CLOSES
TOGETHER
SET SCREW
\
g
I SELF-THREADING
SCREW
2"PULLEY 1
BELT GUARD
BELT GUAHD _\
SUPPORT
MOTOR MOUNTING
BRACKET
CARRIAGE BOLT
5f16.18 X 3/4
MOTOR
MOTOR MOUNTING
BRACKET
11