Xerox 4219/MRP Operator's Manual page 79

XEROX MRP FAMILY FAX MODEM FOR MS-DOS OPERATOR GUIDE
The Fax Setup section of the Printer Configuration Report reports
the following default fax settings:
Fax mode eports which mode is currently in place with the fax modem:
R
send and receive, send only, receive only, disabled.
Clock setup Reports the date and time currently set for fax reporting.
Send setup Reports how a fax is to be sent.
Redial count—Reports the number of redial attempts currently in
place.
Redial interval—Reports the time period between redial
attempts currently in place.
Transmission resolution—Reports if the resolution for outgoing
faxes is set at fine or standard.
Speaker—Reports if the speaker is enabled or disabled.
Header—Reports if a header is printed on outgoing faxes.
Receive setup Reports how a fax is to be received.
Ring count—Reports the number of rings to allow before
answering on incoming faxes.
Input tray—Reports which paper tray is selected as the default
input tray for incoming faxes.
Automatic tray switching—If enabled, "Enable (Trays 4,1,2,3)" is
reported.
Output destination—Reports which default output tray is
selected for incoming faxes.
N Note: If necessary, refer to the "Getting started" chapter in
the Xerox MRP Family 4220/MRP, 4230/MRP Operator Guide
for the procedures to print the report and a report example.
TROUBLESHOOTING
5-7