Black & Decker BD200TMT Instruction Manual page 8

o
o
Position the accessory so the working edge is
away from the tool as shown in Figure 3.
Slide the accessory between the shaft and the
accessory holder making sure the accessory
fully engages the pins on the holder and is flush
with the shaft.
Release the accessory clamp lever.
O
I
Installing/Removing Accessories
(BD200TIViT & BD2001ViT)
• Some accessories, such as scrapers and
blades can be mounted at an angle if required
as shown in Figure 4.
O
• A triangle shaped base, or platen, uses a hook and
loop adhesion system to attach the sanding sheets.
• Attach the sanding platen as described
under "Assembly."
• Align the edges on the sanding sheet, with
the edge of the sanding platen and press the
sanding sheet onto the platen as shown in
Figure 5.
• Firmly press the base with the sanding
sheet attached against a flat surface and
briefly switch the tool on. This provides for
good adhesion between the platen and the
sanding sheet and also helps to prevent premature wear.
When the tip of the sanding sheet becomes worn, detach the sheet from the
platen, rotate and reapply.