How To Use - Black & Decker First Impressions ICR500 Use And Care Book Manual

Product may vary slightly from what is illustrated.






Fabric guide
1 2 3
Synthetic Nylon • Silk Polyester • Rayon
1. Spray nozzle
2. Water-fill cover
3. Fabric select dial
4. Spray button
5. Steam button
6. Automatic shutoff light
7. Comfort Grip ® handle
8. Cord reel button
9. Slip-resistant heel
10. Fabric guide
11. Water tank
®
12. AUTO CLEAN button
13. Soleplate
14. Button groove









4 5 6
Cotton Blends Wools Cotton • Linen
Symbols
Surge of steam
Spray
Anti drip system

How to Use

This appliance is intended for household use only.
GETTING STARTED
• Remove any labels, stickers or tags attached to the body or soleplate of the iron.
• Please go to www.prodprotect.com/applica to register your warranty.
Note: Use ordinary tap water for ironing. Do not use water processed through a home
softening system.
Important: For optimum performance, let the iron stand for 90 seconds before
beginning to iron.
Tip: If unsure of a garment's fiber, test a small area (on an inside seam or hem) before
ironing.
FILLING WATER TANK
. open the water-fill cover (A).
A
. Tilt the iron and using a clean measuring cup, pour water into
opening until the water reaches the MAX level mark on the
water tank (B). Do not overfill.
. Close the water-fill cover.
B
. Plug in the iron. A solid red light comes on and stays on until
the set temperature is reach. once the set temperature is
reached, the light turns solid green (C).
Note: If you need to add water while ironing, unplug the iron and
follow above steps.
C
SPECIAL FEATURES
Automatic Shutoff in 3 Positions
• Your iron will automatically turn off after 0 seconds of
inactivity if left on its soleplate or on its side. If left vertically on
its heel rest, it will turn off after 8 minutes (D).
30 seconds
• The unit beeps five times and there is a flashing red light to
indicate the iron is in the automatic shutoff position.
8 minutes
• once you pick up the iron, the light will turn solid green again
D once the set temperature is reached. If the iron is not fully
heated, a solid red light will appear; once the iron is ready, the
light will turn solid green.
Note: Wait for iron to reheat completely before resuming operation.
Anti-Drip System
The anti-drip system prevents water spotting at low temperatures.
5