JVC HX-D7 Instructions Manual page 60

Turn the power off to all components before
connections.
To assembleand connectthe AM loopantenna
To assemble the AM loop antenna
To connect the AM loop antenna cords
• Connect black cord to the rb terminal, and the white cord to
the other terminal.
@ Hold
O) Insert
@ Release
If the AM loop antenna wire o1" speaker cords are covered with
vinyl, remove the vinyl to expose the tip of the antenna by
twisting tire vinyl.
• Make sure the antenna conductors do not touch any other
terminals, connecting cords and power cord. Also, keep the
antennas away from metallic parts of the System, connecting
cords, and the AC power cord. This could cause poor
condition.
To connect digital audio
Protective cap
To connectthe speakercords
• When connecting the speaker cords, match their polarity
with that of the speaker terminals: red/blue to (+) and
black to (-).
• Use only speakers with the same speaker impedance as
indicated by the speaker terminals on the rear of the unit.
• The speakers are nmgnetically shielded to avoid color
distortions on TVs. However, if not installed properly,
it may cause color distortions. So, pay attention to the
following when installing the speakers.
When placing the speakers near a TV set, turn off the
TV's main power switch or unplug it before installing
the speakers.
Then wait at least 30 minutes before turning on the
TV's main power sw'itch again.
Some TVs may still be affected even though you have
followed the above instruction. If flais happens, move
the speakers away from the TV.
each terminal.
i_ • DO NOT pusb or pull the speakers as this
will damage the foot spacers at the bottom of
the speakers.
@ Hold @ Insert
Blue
@ Release
From left speaker
Black
Y
Black
From right speaker
Red
IMPORTANT
Always set volume to VOL MIN when connecting or
disconnecting the other equipment.
i_IHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHHr_HHHHHHHr_jI;_jIH
/_ DO NOT plug in any eqeipment until all
iI _ connections are complete.
7