Rear Panel - JVC RX-DV31SL Instructions Manual

Basic OpePations
• Listening with headphones
Connect a pair of headphones to the O (phones) jack on the
front panel. This cancels the Surround mode currently
selected, deactivates speakers, and activates the
HEADPHONE mode.
The SPK 1 and 2 indicators go off from the display.
. Disconnecting a pair of headphones from the 0 (phones)
jack cancels the HEADPHONE mode and activates
speakers.
HEADPHONE mode
When using the headphones, the following signals are
output regardless of your speaker setting:
For 2-channel sources, the front left and right channel
signals are output directly from the left and right
headphones.
For multi-channel sources, the front left and right,
center, and surround channel signals are dowmmixed
and then output from the headphones without missing
bass element.
For DVD AUDIO ONLY: When down-mixing is prohibited
on the disc, only signals of the front left and right channel
are output.
CAUTION:
Be sure to turn down the volume:
• Before connecting or putting on headphones, as high
volume can damage both the headphones and your
hearing.
• Before removing headphones, as high volume may come
out of the speakers.
When you have connected two pairs of front speakers, you
can select which to use.
On the front oanel ONLY @
To use both pairs of the speakers
Press SPEAKERS 1 and 2 so that the SPK 1 and 2 indicators
light up on the display.
To use neither pairs of the speakers
Press SPEAKERS 1 and 2 so that the SPK 1 and SPK 2
indicators go off from the display.
Notes:
• ffyou select any of the Surround modes while using both pairs of
the front speakers connected to the FRONT SPEAKERS 1 and 2
terminals, the speakers connected to the FRONT SPEAKERS 2
terminals are deactivated.
• While the Surround mode is in use, you can only select either the
speakers connected to the FRONT SPEAKERS 1 or 2 terminals.
When you connect a CD recorder to the TAPE/CDR jacks on
the rear panel, change the source name which will be shown
on the display.
On the front oanel ONLY
Ex.: When changing the source name from "TAPE "to
"CDR"
I Press TAPE/CDR (SOURCE NAME) to select
as the source.
2 Press and hold SOURCE NAME (TAPE/CDR)
until "ASSGN. CDR" appears on the display.
[] [] ,"% _ ,"' ,'% I I ,"% I_, I"%
= = 'i ',,, == =', = ' ' ' ' '
r"l -, ....,,.J I 'I = i . L_ i'=:. _ 15
To use the speakers connected to the FRONT SPEAKERS
1 terminals
Press SPEAKERS 1 so that the SPK 1 indicator lights up on
the display. (Make sure that SPK 2 is not lit on the display.)
To use the speakers connected to the FRONT SPEAKERS
2 terminals
Press SPEAKERS 2 so that the SPK 2 indicator lights up on
the display. (Make sure that SPK 1 is not lit on the display.)
To change the source name to "TAPE"
Press and hold S©URCE NAME (TAPE/CDR) until
"ASSGN TAPE" appears on the display in step 2.
Note:
• Without changing the source name, you can still use the connected
components. However, there may be some inconveniences:
- The unexpected source name wil! appear on the display when you
press TAPE/CDR (SOURCE NAME) on the front panel
- The CDR or TAPE button on the remote control will not work for
selecting the source.
- You cannot use the digital input (see page 25) for the CD
recorde_
]3