Preparations; Checking The Accessories; Installing The Batteries; Attaching The Ferrite Core - JVC GM-V42UB Instructions Manual

Plasma display monitor
Hide thumbs Also See for GM-V42UB:
Table of Contents

Advertisement

Preparations
['he following
accessories
are included
with the Monitor. Check for them. If any item is missing,
please contact the dealer where
you purchased
the Monitor.
* Remote control (RM-C579) x 1
* Power cord x 1
* Batteries (AA/R6P)
x 2
* Ferrite core x 1 (Only for GM-V42UG)
Put the batteries
in the remote control as follows. If the remote control has become erratic in operation,
change the batteries.
1
Remove
the back cover.
While pushing
the release lever on the cover, remove
the cover in
the direction
of the arrow.
2
Place the batteries.
Put the two supplied
batteries
(AA/R6P),
noting the (_ and (_
markings,
as shown.
3
Replace the back cover as illustrated.
Make sure the release lever on the cover is locked in place correctly_
Precautions for using batteries
If batteries
are used improperly,
the liquid could leak out, causing a fire, injury, etc. or dirtying
the vicinity:
Take notice of the following:
* Do not mix old and new batteries.
* Do not mix different
types of battery
as different
types may have different
characteristics.
* Place the batteries
according
to the (_ and _@markings
indicated
on the battery
compartment.
* When installing
the batteries,
insert the @ end first to avoid a short circuit.
* Use only the specified batteries.
* When you are not using the remote control for a long time, remove the batteries.
* When the batteries
have reached the end of their life, replace them with new ones immediately.
Otherwise,
the liquid may leak
out, or malfunction
may be caused by the leaked liquid. If the leaked liquid contacts your skin, wipe off the liquid with a soft
cloth. If the affected skin is left as is, you may get a rough skin.
* Do not throw the batteries
into fire or try recharging
them.
* The service life of batteries
is six months
to one year for normal use. The supplied
batteries
are only for checking
the operation
and their life may be shorter. When the remote control operation
becomes
erratic, replace with new batteries.
Attach the ferrite core to the power cord. Using the power cord without
the ferrite core may lead to noise (interference).
Open
the ferrite core, insert the power cord and close the ferrite core. Attach the ferrite core to the AC IN end of the power cord.
Ferrite core *
""-}_
Power cord
Plug to AC IN
* Not supplied
to GM-V42UB
8

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gm-v42ug

Table of Contents