Table of Contents
Advertisement
Connect}ng
an external
control
un}t
When connecting
the external
control unit to the MAKE terminal,
you can operate
the following
functions
through
the
MAKE terminal;
• Turn on or off the Monitor.
Preparation:
The POWER switch on the rear must be set to "I (on)" (so that the Monitor
is in standby
mode).
• Select the input.
Preparation:
"REMOTE
SWITCH"
should be set correctly
to select your desired input
(see page 27).
Notes:
o There is no remote control on/off
switch. When a plug is inserted
to the MAKE terminal,
remote control through
the
external
control unit is automatically
activated.
• When the other REMO FE terminals
are used at the same time, transmitted
commands
through
the MAKE terminal have
priority over those through
the other terminals.
'_ MAKE terminal
" External
control
unit
6
5
4
3
Pin number
Signal name
1
GND
2
GND
3
SW2
4
SW1
5
SW DET
6
GND
Signals
transmitted
TTL level
H: Power Off
H: Input A*
H: Not connected
Input A and Input
SWITCH" setting.
L: Power On
L: Input B*
L: Connected
will be determined by the "REMOTE
IMPORTANT:
External
control unit is not commercially
available
in the market.
When you need it, consult your dealer.
Connecting
the Cooling Fan Unit (not supplied)
When installing
this Monitor
vertically,
it is required
to attach the Cooling Fan Unit.
Note:
If you install the Monitor
in such a way not instructed
in this manual
(for example,
installing
it diagonally),
the
Cooling Fan Unit may not be able to cool down the internal
heat enough
to make the Monitor
operate;
therefore,
reinstallation
or another
method
for cooling will be required.
* For more detailed
connection,
refer to the manual
supplied
with the Cooling Fan Unit.
Cooling Fan Unit:
>"
TS-C01FANG(Option)
/
/
IMPORTAN
T:
When installing
the Monitor
vertically, consul t you r d ea let.
13
Advertisement
Table of Contents
