Replacing The Filter Cartridge - Sanyo XC50 - PLC XGA LCD Projector Owner's Manual

1
Turn off the projector, and unplug the AC power cord
from the AC outlet.

First, clean up the dust on the projector and around the
air vents.

Loosen 2 screws of the filter cover with a screwdriver
and open the filter cover.
4
Rotate the handle of the filter and pull out the filter
cartridge.
5
Put the new one back into the position and rotate back
the handle. Make sure that the filter cartridge is
properly and fully inserted. Close the filter cover and
tighten the 2 screws back into position.
6
Connect the AC power cord to the projector and turn
on the projector.
7
Reset the filter counter and the scroll counter (p.62).
CAUTION
Make sure the filter cartridge is inserted in the
projector. If the filter cartridge is not inserted, the
projector cannot be turned on.
Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when
operating the projector. Usage in these environments may
cause a poor image quality.
When using the projector under dusty or smoky conditions,
dust may accumulate on a lens, liquid crystal panels, or
optical elements inside the projector. Such condition may
degrade the quality of the projected image.
When the symptoms above are noticed, contact your
authorized dealer or service station for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Replacement filter cartridge can be ordered through your
dealer. When ordering, give the following information to
the dealer.
● Model No. of your projector
PLC-XC50A
● Replacement Filter Cartridge Type No.
POA-FIL-063
(Service Parts No. 610 339 7665)

Replacing the Filter Cartridge

Maintenance and Cleaning
Filter cover
Screws
CLOSE
handle
OPEN
handle
Filter cartridge
61