Maintenance; Replacing The Filter Cartridge - Sanyo PLC-XC50 Service Manual

Maintenance

Replacing the Filter Cartridge

Turn off the projector, and unplug the AC power cord
1
from the AC outlet.
First, clean up the dust on the projector and around
2
the air vents.
Loosen  screws of the filter cover with a screwdriver
3
and open the filter cover.
Rotate the handle of the filter and pull out the filter
4
cartridge.
Put the new one back into the position and rotate
5
back the handle. Make sure that the filter cartridge is
properly and fully inserted. Close the filter cover and
tighten the  screws back into position.
Connect the AC power cord to the projector and turn
6
on the projector.
7
Reset the filter counter and the scroll counter.
CAUTION
Make sure the filter cartridge is inserted in the pro-
jector. If the filter cartridge is not inserted, the pro-
jector cannot be turned on.
Do not put anything into the air vents. Doing so may
result in malfunction of the projector.
RECOMMENDATION
We recommend avoiding dusty/smoky environments
when operating the projector. Usage in these environ-
ments may cause a poor image quality.
When using the projector under dusty or smoky condi-
tions, dust may accumulate on a lens, liquid crystal pan-
els, or optical elements inside the projector. Such condi-
tion may degrade the quality of the projected image.
When the symptoms above are noticed, contact your
authorized dealer or service station for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Replacement filter cartridge can be ordered through your
dealer. When ordering, give the following information to
the dealer.
● Model No. of your projector
PLC-XC50/PLC-XC55
● Replacement Filter Cartridge Type No.
POA-FIL-063
(Service Parts No. 610 339 7665)
Filter cover
CLOSE
handle
OPEN
handle
-7-
Screws
Filter cartridge