Sanyo XC50 - PLC XGA LCD Projector Owner's Manual page 51

Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready ............... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition,
the projection lamp will be turned on if
the input signal is reconnected or any
button on the top control or remote
control is pressed.
Shut down .......
When the lamp has been fully cooled
down, the power will be turned off.
Off .................... Power management function is off.
Timer ................ If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with
No signal appears. It starts the
countdown until the lamp is turned off.
Use the Point ▲▼ buttons to set the
Timer(1~30min).
Note:
Factory default is Ready: 5 min.
On start
When this function is set to On, the projector will be automatically
turned on just by connecting the AC power cord to a wall
outlet.
Note:
Be sure to turn off the projector properly (see "Turning
Off the Projector" on page 20). If the projector is turned
off in the incorrect sequence, the On start function does
not work properly.
Standby mode
This function is available when the projector is turned off
and in Stand-by. It is recommended to use Eco under
normal condition.
Serial ......... Normal power consumption in Stand-by
condition.
Eco ............ Lower power consumption than Serial mode
in Stand-by condition.
Note:
• Factory default is Serial.
• When Eco mode is selected and the projector is in Stand-by,
the communication of RS-232C serial port is not available.
Power management
Time left before Lamp is off.
Closed caption
Setting
Ready
51