Auto Pc Adjustment - Sanyo XC50 - PLC XGA LCD Projector Owner's Manual

Computer Input
Auto PC Adjustment function is provided to automatically adjust Fine sync ., Total dots, Horizontal, Vertical,
Clamp, Display area H and Display area V positions to conform to your computer.
Menu Operation
Auto PC adj .
1
Press the MENU button to display the On-Screen
Menu. Use the Point
and then press the Point

Use the Point
▲▼
then press the SELECT button.
To store adjustment parameters
The adjusted parameters from the Auto PC Adjustment can
be stored in the projector. Once the parameters are stored,
the setting can be done just by selecting a Mode (1–5) in
the PC System Menu (see page 29). See also "Store" on
page 32.
Note:
• Fine sync, Total dots, Horizontal and Vertical
position of some computers cannot be fully adjusted
with the Auto PC Adjustment function. When the image
is not provided properly with this operation, manual
adjustments are required (pp.31-32).
• The Auto PC Adjustment cannot be operated when 480i,
575i, 480p, 575p, 70p,105i or 1080i is selected in the
PC System Menu (p.29).
0

Auto PC Adjustment

buttons to select PC adjust
▲▼
or the SELECT button.
►
buttons to select Auto PC adj . and
PC adjust Menu
Use Point
▲▼
adj . and press the SELECT button.
Please wait . . . appears while the Auto PC
adjustment is in process.
buttons
to select Auto PC