Creating A Gutter; Punch; Creating Punch Holes For A Print Job - Kyocera TASKalfa 552ci User Manual

Creating a Gutter

1
2
3
4
5

Punch

Creating Punch Holes for a Print Job

1
2
KX DRIVER
creates a larger margin space by shifting the printable area to the right, or down
as much as one inch (25.4 mm).
You can increase the margins on the left side and at the top of the printed sheet.
In the Finishing tab, click Gutter.
In the Gutter width options, type or select a value between 0.20 to 1.00 inches
(5.0 to 25.4 mm).
Long edge (left)
This selection modifies the outside margin on the left-side of the page.
Short edge (top)
This selection modifies the outside margin on the top-edge of the page.
Note: Availability of Gutter settings vary depending on Finishing edge
settings, and Orientation and Duplex mode settings in the Basic tab.
If text extends too close to the edge of the page, select Reduce image to fit.
The text appears slightly reduced and away from the edge of the page. If text
does not extend beyond the page when the gutter increases, clear Reduce
image to fit.
Click OK to return to the Print dialog box.
Click OK to start printing.
The Punch feature places punched holes along the edge of the printed pages
so that the pages can be bound together or placed in a binder.
Punch is enabled when a 3000-sheet finisher is selected in Device options in
Device Settings. When you select the check box for a finishing device shown in
blue in the Device options list, the Punch Unit Settings dialog box appears. If
the device listing is already selected, double-click the option to open the Punch
Unit Settings dialog box.
Punch cannot be used when Booklet is selected in the Layout tab.
Finishing edge should be selected before any other features in the Finishing
tab. If set last, Finishing edge might change any settings that you previously
made under Punch.
The finishing device must support the Punch feature.
Available punch options are set in Device Settings and depend on the punch
unit installed on the device and selected.
In the Finishing tab, select Punch.
Select the number of hole punches:
Finishing
6-5