Table of Contents
Advertisement
GETTING
STARTED
Step 3f, Digital 8VSB Cable/Analog
Cable with Conventional
TV
Follow this diagram if you have a conventional
TV, cable service providing 8VSB
digital cable and you want to receive digital cable channels through the STB and
analog cable channels through the cable box (or through the TV if you have no cable
box).
Note:
The STB is able to receive DTV signals from your local cable provider only if they are
transmitted in the 8VSB
modulation format approved by the FCC
for DTV
transmission. Also, your cable provider may elect to transmit in the 8VSB format for
only a limited period of time. Please contact your cable provider to determine ff
8VSB modulation is available.
Analog Signal
Optional Cable Box
ANT
IN
ANT
OUT
TV
NOTE: ANTENNA, SPLITTER, CABLE BOX, RF
CABLES,
S-_DEO,
VIDEO
AND
AUDIO
CABLES NOTINCLUDED
8VSB Signal
ANT
IN
INPUT
AUDIO
LR
STB
SER_L
NO
........ =
M' []
' '
MODE
R-AUDIO'L
VIGEO
S
ALL ATSC
_
DIGITAL
NTSC OUTPUT
FORMATS
41J0p
DIGITAL
AUDIO
OUT
400p.1080i
INTERFACE
(AC-3)
L
DIGITAL 8VSB CABLE/ANALOG
CABLE RECEPTION WITH
CONVENTIONAL
TV SETUP
-=//
Procedure
•
Connect the cable wire from the wall jack to the splitter using a standard RF cable with
coaxial connectors.
Connect one splitter output to the STB ANT (antenna) IN jack using a RF cable.
If using a cable box, connect the other splitter output to the cable box ANT (antenna) IN
jack using a RF cable. Connect the cable box ANT (antenna) OUT jack to the "IV ANT
(antenna) IN jack using a RF cable.
If not using a cable box, connect the other splitter output to the IV ANT (antenna) IN jack
using a RF cable (not shown).
Follow directions in Getting Started section to connect the STB to a conventional TV.
[]
Advertisement
Table of Contents
