Epson STYLUS 4800 Printer Manual page 131

Message Light
CHANGE PAPER
TYPE on
COMMAND —
ERROR
DRIVER INK SET —
SETTING IS
WRONG
MISMATCH
ERROR
Note:
These messages
alternate.
FEED SHEET —
PAPER
FEED SHEET
PAPER
MANUALLY
FORBIDDEN —
MEDIA FROM P.
TRAY
INK LOW B Ink light
flashing
INK OUT B Ink light on
When your ink or paper runs out or a problem occurs, a message appears on
the LCD display, and the lights on the control panel come on or flash. The
following table lists the messages in alphabetical order and includes an
explanation and instructions for correcting the problem.
Explanation
Paper light Paper loaded does not
match the source
selected.
You're using the wrong
printer driver.
Damaged data was
sent to the printer or
the data has an
incorrect command.
The installed printer
driver is not correct for
the printer.
The black ink cartridge
option does not match
what is selected in the
driver
Non-Epson genuine ink
cartridge is installed.
Cut sheet needs to be
loaded manually.
Cut sheet needs to be
loaded manually.
Ink cartridge(s) are
nearly empty (printing
continues).
Ink cartridge(s) are
empty (printing stops).
Response
Press the
correct setting: either
or or
Press the
seconds to cancel the print job. Make sure you
installed the correct driver for your printer.
Press the
seconds to cancel the print job.
Stop printing, and press the
3 seconds. Then make sure that the installed
printer driver is correct for the printer.
Stop printing, and then press and hold the
Pause button for 3 seconds. Select the correct
black ink cartridge option in the driver. See
page 116. If you want to continue printing,
press the
Press the
cancel printing. If you want to continue printing,
press the
Load the sheet in the manual feed slot. See
page 44 for instructions.
Load the sheet in the manual feed slot. See
page 44 for instructions.
Make sure you have replacement cartridges
available. See page 109.
Replace the ink cartridge(s) indicated on the
LCD panel. See page 109 for instructions.
6-131
Solving Problems
Paper Source button to select the
(for paper in the tray,
for roll paper)
.
Pause button and hold it for 3
Pause button and hold it for 3
Pause button for
Pause button.
Pause button for 3 seconds to
Pause button.
| 131