Using Overcasting Foot - Brother XR1300 Operation Manual

UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Using overcasting foot

a Attach overcasting foot "G".
b Select stitch or
• For details, refer to "Selecting a stitch"
(page 37).
c Position the fabric with the edge of the fabric
against the guide of the presser foot, and then
lower the presser foot lever.
a Guide
d Slowly turn the handwheel toward you
(counterclockwise) and check that the needle
does not touch the presser foot.
Sew with the edge of the fabric against the
e
presser foot guide.
a Needle drop point
CAUTION
● After adjusting the stitch width, slowly turn
the handwheel toward you
(counterclockwise) and check that the needle
does not touch the presser foot. If the needle
hits the presser foot, the needle may bend or
break.
a Check that the needle does not touch the
presser foot.
46
.
1