Brother XR1300 Operation Manual page 29

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d Fully lower the needle threader lever.
The end of the needle threader rotates
toward you and the hook passes
through the eye of the needle.
e Catch the thread on the hook as shown below.
a Hook
b Thread
f While lightly holding the thread, release the
needle threader lever. The hook will pull the
thread through the needle.
g Pull the loop of the thread passed through the
eye of the needle toward the rear of the
machine.
a Loop of thread
CAUTION
● Be careful not to pull on the thread with force
or it may bend the needle.
● If the thread does not pass through the eye of
the needle, start from step
h Raise the presser foot lever.
a Presser foot lever
i Pass the end of the thread through the presser
foot, and then pull out about 5 cm (2 inches)
of thread toward the rear of the machine.
a 5 cm (2 inches)
Note
● If you incorrectly feed the thread you may
cause sewing problems.
c
again.
27
1