Brother XR1300 Operation Manual page 101

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
p Insert the bobbin case so that the
the bobbin case aligns with the
machine.
• Align the
a mark
b mark
c Bobbin case
• Make sure that the indicated points are
aligned before installing the bobbin case.
CAUTION
● Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or sewing
performance may suffer. For a new bobbin
case (part code: XE7560-001), contact your
nearest authorized service center.
● Make sure that you fit the bobbin case
properly, otherwise the needle may break.
q Attach the needle plate cover according to
h
steps
(page 91).
and marks.
i
and in "Cleaning the race"
mark on r Check the condition of the needle, and then
mark on the install it.
If the needle is in a poor condition, for
example, if it is bent, be sure to install a new
needle.
• Refer to "Checking the needle" (page 30)
● Never use bent needles. Bent needles can
easily break, possibly resulting in injuries.
● After completing this procedure, continue
● Since the needle may have been damaged
and "Replacing the needle" (page 30).
CAUTION
Note
with the following procedure in "Checking
machine operations" to check that the
machine is operating correctly.
Memo
when the fabric was caught in the machine,
we recommend replacing it with a new one.
4
99