Sewing Characters (For Models Equipped With Character Stitches); Selecting Characters - Brother XR1300 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
SEWING CHARACTERS
55 characters can be sewn by following the procedure below.

Selecting characters

■ Selecting a character
[Example] Selecting stitch "C" (No. 03).
a Turn on the sewing machine.
b Press the stitch category selection key twice
and confirm that the character stitch indicator
lights up.
a Stitch category selection key
b Character stitch indicator
Memo
● When you select a character, check that
there are no characters in memory.
a This indicator shows that no character is stored.
If there are any characters in memory,
delete them. (For details, refer to "Deleting
characters" (page 75).)
c Press
pattern No. 03.
• For details, refer to step
stitch" (page 37).
(for models equipped with character stitches)
(stitch selection keys) to select
c
of "Selecting a
d Press the "+" side of
adjustment key) to enter the selected
character.
N
a Stitch width adjustment key
The following display is shown on the
LCD.
N
a Selected pattern No.
b The position of the selected pattern No.
c The total number of entered characters
e Attach the presser foot indicated on the LCD.
a The presser foot to use
• For details, refer to "Replacing the presser
foot" (page 34).
f If you would like to only sew this single
character, start sewing.
If you would like to sew a sequence of
characters, go to step
characters" (page 74).
• For details on sewing characters, refer to
"Sewing the character stitches" (page 76).
(stitch width
a
on "Combining
73
3