Brother Quattro 6000D Operation Manual page 25

f
Select how to change the pattern size.
* Press to enlarge the pattern proportionately.
* Press to shrink the pattern proportionately.
* Press to stretch the pattern horizontally.
* Press to compact the pattern horizontally.
* Press to stretch the pattern vertically.
* Press to compact the pattern vertically.
* Press to return the pattern to its original appearance.
Memo
• With the density scale bar, the thread density can be
changed.
A setting between 80% and 120% in 5% increments
can be specified.
* Press
* Press
24
to make the pattern less dense.
to make the pattern more dense.
g
Press .
h
Press .
Note
• Depending on the pattern, embroidering may not be
possible at the appropriate thread density. Before
sewing on your project, be sure to sew trial
embroidery on a piece of scrap fabric that is the
same as the fabric used in the project using the
same needle and embroidery thread.
• If the pattern is enlarged and there is space between
stitches, a better effect can be achieved by
increasing the thread density.
• If the pattern is reduced and the stitching is too thick,
a better effect can be achieved by reducing the
thread density.
CAUTION
• Depending on the pattern, the stitching may
become entangled or the needle may break when
the pattern is reduced. If this occurs, slightly
enlarge the pattern.