Brother Quattro 6000D Operation Manual page 23

■ Positioning the pattern on thick fabric
When positioning the pattern on thick fabric such as
quilting, the fabric may not be detected correctly. In
order for the fabric to be correctly detected, its
thickness must first be measured.
Memo
• This feature is functional only when the fabric is
scanned. It will not affect embroidering if it is turned
on with normal embroidery.
a
Hoop the fabric in the embroidery frame, and
then attach the frame to the embroidery
machine.
b
Select the pattern, and then press
c
Display page 8/8 of the Settings screen, and
then set "Fabric Thickness Sensor" to "ON".
d
Press
e
Press
22
.
.
f
Affix the embroidery positioning sticker to the
fabric within the area indicated by the red
frame in the LCD, and then press
.
g
When the following message appears, remove
the embroidery positioning sticker, and then
press
→ The embroidery frame is moved, and the
embroidery positioning sticker affixed to the fabric is
detected.
h
Continue with step
pattern with the desired embroidery position.
• Use fabrics with a thickness of less than 3 mm
(approx. 1/8 inch). Using fabrics thicker than 3 mm
(approx. 1/8 inch) may cause the needle to break.
.
f
on page 21 to align the
CAUTION
.