Sony WEGA KDS-R60XBR2 Operating Instructions Manual page 76

Other Information
The TV does not turn on _ The TV cools down its proiection lamp when the power is turned off. It takes up to
two minutes t_r the picture to come back after the TV is turned on again. Wait for
a while until the picture comes back.
Small bright or black clot in _ It may be possible to see several pixels, which appear clark or bright when viewing
picture up close to the screen caused during the manufacturiug of the display device. This
is not a defect with your TV and will not affect the overall picture performance or
reliability of your set. Please view the screen at the recommended viewing
distances.
Image left on the screen (image _ Turn off the TV for a while or let the TV run on another channel. Unlike plasma
retention) TV and CRT TM image retention on this TV is not permanent. It is only a
temporary condition; see page 10.
Uneven color uniforlnity _ Alter turning on the TM you may notice a slight variation in color (tint) and
appears on the screen when the brightness in certain areas of the picture. This will last only a few minutes each
TV is powered on time you turn on the TV. This is a normal temperature characteristic of the
components and not a malfunction.
White spot on the screen when _ If screen is exposed to direct sunlight or strong ambient light, part of the screen
powered off may appear white even when TV is power off. This is due to the strong light
reflecting oft" the TV screen and reflections coming behind the screen. This is a
structural property of the pro}ection TV and is not a defect. Position your TV
away from such light sources.
"Proiection lamp is nearing end _ It is time for you to replace the projection lamp used in your TV.
of life. Please replace the • Turn to page 66 on "How to Replace the Lamp" and follow the directions for
lamp." message appears replacing the lamp.
• Use only the lamp designated for your TV model.
• Set the Lamp Replacement option in the Setup settings (see page 62).
76