Sony Handycam CCD-FX520 Operation Manual page 49

Symptom Cause Corrective Actions
The image on the The viewfinder lens is not Adjust the viewfinder lens.
viewfinder screen is not adjusted. 11
clear,
A vertical band appears The contrast between the Change locations.
when a subject such as subject and background is too
lights or a candle flame high: The camcorder is not
is shot against a clark malfunctioning.
background.
The playback picture is The EDIT switch is working. Set EDIT in the opposite
"_ not clear, direction of the arrow.
34, 43
The channel or input for the Select correctly.
camcorder is not selected on 22
the TV.
E The video heads may be Clean the heads using the Sony 38
contaminated. V8-25CLH cleaning cassette.
The IN/OUT selector is set to Set it to OUT.
IN.
G)
J=
When the TV is
connected to the
camcorder using the
VIDEO/AUDIO jacks,
the picture on the TV is
not clear or moves
vertically.
The supplied Remote
Commander does not
work.
There is dust inside the
viewfinder.
The HOLD switch is working.
The REMOTE COMMANDER
switch is set to OFF.
The batteries are not inserted
with the correct polarity.
The batteries are dead.
Set the switch in the direction
opposite to the arrow.
Set it to ON.
Insert the batteries with the
correct polarity.
Insert new ones.
Pull out the viewfinder and clean
the viewfinder screen or
viewfinder lens.
22
23,46
24
24
24
38
When the CHARGE lamp on the AC power adaptor flashes
Check through the following chart.
Remove the battery pack from the AC power
adaptor.
1| the CHARGE lamp flashes again, install
another battery.
I The CHARGE lamp lights up.
1
The CHARGE lamp flashes.
install the same battery again.
I If the CHARGE lamp lights up and goes out
after a wh e, the battery s operat ng correct y._
_--_ If the CHARGE ramp goes out after a while, the
problem is with the battery firstlyinstalled.
_,',_ The problem is with the AC power adaptor.
Please contact your nearest Sony dealer.
_' If you use a battery pack which you have just brought or which has been left unused for a long time, the
CHARGE tamp may flash at the first charging. But this is not a problem. Continue to charge with the same
battery pack.
Note on the POWER lamp
The POWER lamp will remain lit for a while even if the unit unplugged after using. This is normal.
8
¢..
o-
C)
ZT
CD
O
49