Sony Handycam CCD-FX520 Operation Manual page 25

You can choose any of the following power sources for your camcorder: Battery pack (P.6), house current,
and 12/24 V car battery.
The appropriate power source for you to choose depends on where you want to use your camcorder.
I PlaCe Power source Accessory to be used ,i i
Battery pack NP-55 (supplied), NP-77H/77HD, NP-77,
Outdoors Battery pack NP-66H or NP-55H
Indoors House current AC power adaptor AC-V25 (supplied), AC-V30 or AC-S10
In the car 12 V or 24 V car battery DC pack DCP-77
Note on power sources
Disconnecting the power source or removing the battery pack during recording or playback may damage the
inserted tape. If this happens, supply the power again immediately.
Using House Current
Use the supplied AC-V25 AC Power Adaptor. (1) Align the right side of the AC power adaptor with the white
line on the camcorder. While pressing the lower part of the AC power adaptor, slide it to the right until it clicks.
(2) Connect the power cord of the AC power adaptor to a wall outlet. (3) Set the VTR (DC OUT)/CHARGE
selector on the AC power adaptor to VTR (DC OUT).
2
3
To detach the AC power adaptor
Detach it in the same way you do it with the battery pack. (p. 7)
Notes on the AC power adaptor
• Before attaching the AC power adaptor to the camcorder, detach the battery pack from the AC power
adaptor.
• The camcorder does not operate unless the VTR (DC OUT)/CHARGE selector is changed to VTR (DC
OUT).
• The POWER lamp will remain lit for a while even if the battery pack is detached and the power cord is
disconnected after charging the battery. This is normal.
• If the power lamp does not light, set the VTR (DC OUT)/CHARGE selector to OFF and disconnect the power
cord. In about one minute, reconnect the power cord and set the VTR (DC OUT)/CHARGE selector to VTR
(DC OUT) again.
73
_.7-
(.c}
O3
Cb
.-I
c
f./).
"7
3
0
-0
o
0
0
C
0
25