Sony Handycam CCD-FX520 Operation Manual page 48

Ifyou run into any problems using the camcorder, use the following table totroubleshoot the problem.
3=
no
Symptom I
The power does not
go on.
The power goes off.
The battery pack is
quickly discharged.
START/STOP does
not operate.
The cassette cannot
be removed from the
'_ compartment.
_. No function except for
O cassette ejction works.
The tape does not
move when a tape
transport button is
pressed.
The autofocus
function does not
work.
Cause
The battery is not attached.
The battery is empty.
The AC power adaptor is
not connected to a wall
outlet.
While being operated in
CAMERA mode, the
camcorder has been in the
pause mode for more than 5
minutes.
The battery is empty.
The ambient temperature is
too low.
The battery pack has not
been charged fully.
The battery pack is
completely dead, and
cannot be recharged.
The tape is stuck to the
drum.
Corrective Actions
Attach the battery.
Use a charged battery.
Connect the adaptor to a wall
outlet.
Turn STANDBY down at once
and turn it up again.
Use a charged battery.
Charge the battery pack
again.
Use another battery pack.
Eject the tape.
The tape has run out. Rewind the tape or use a new
one.
Set it to CAMERA.
The POWER switch is set to
VTR.
The tab on the cassette is
out (red).
The battery is exhausted.
Moisture condensation has
occurred.
The POWER switch is set to
CAMERA or OFF.
The tape has run out.
Focus is set to MANUAL.
Shooting conditions are not
suitable for autofocus
operation.
Use a new tape or slide the
red tab.
Use a charged battery or the
AC power adaptor.
Remove the cassette and do
not use the camcorder for at
least an hour.
Set it to VTR.
Rewind the tape or use a new
one.
Set it to AUTO.
Set Focus to MANUAL to
adjust the focus manually.
page
7,25
6
25
17
6
8
6
15
18, 23
17
18
6, 25
37
23
18, 23
26
26
(Continued)
48