II
÷
II
Setting the Channels
After you finish connecting
your TV, you can run
Auto Program
to set up your channels. The Auto
Program
screen appears when you turn your TV on
for the first time after installing
it.
To change or skip channels,
see page 19.
Note
The Auto Program feature does not apply for an installation that
uses a cable box for all channels.
Installing and Connecting the TV
1
Press Power on the front panel of your TV. The
Auto Setup menu appears.
Auto
Setup
Auto
Program:[CH+]
Exit
[CH-I
First
please
connect
cable/antenna
2
Press CH+ on the remote control or on the front
panel of your TV to perform
Auto Program.
÷
2
To perform
Auto Program
again
1
Press MENU.
2
3
4
Press l_/,l_ to select _" (TV Setup), then press
(Z).
Press l_/,l_ to select "Auto Program,"
then press
(i)-
Press l_/,l_ to select "OK," then press @.
"Auto-Channel
Set" appears and the TV starts
scanning and presetting
channels
automatically.
When all the receivable
channels
are stored, the
highest numbered
channel will be displayed,
then
the/_
(TV Setup) menu appears.
5
Press MENU to exit the menu screen.
To cancel Auto Program
While "Auto-Channel
Set" appears in step 4, press
MENU
on the remote.
÷
(Continued)
_us) 17
I
I
01USO4CON-UC(8+t
9} p65
17
÷
2002622,
3:13 PM
KZ-32/42TS 1U 4-087-364-13
(1)
II