Epson Stylus COLOR 300 User Manual page 77

The printer loads more than one sheet at a time.
Cause
The paper may have been
loaded too deeply into the
printer.
Too many sheets are loaded
in the sheet feeder.
The edge guides are not set
correctly.
The paper thickness lever or
the adjust lever position may
not be set correctly.
The paper is too thin.
Ejected paper is wrinkled.
Cause
The paper is too thin or damp. Do not store your paper in a damp or
What to do
Remove the paper and gently reinsert
it straight up and down into the
printer.
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Load paper only up to the arrow
mark on the left edge guide.
Adjust the guides against the stack of
paper. See "Loading Paper" in
Chapter 3.
Make sure the paper thickness lever
and adjust lever positions are set
correctly. See page 4-2.
Make sure the paper meets the paper
requirements for this printer. See
"Paper" in the Appendix.
What to do
humid environment. Store paper in its
original packaging.
Troubleshooting
6
6-13