6.
Press a 50mm Square Inner Cap (22) into the
end of the Top Frame (8).
Attach the Top Frame (8) to the Front Upright (6)
with two M10 x 70mm Bolts (58), the 90mm
Space Support Plate (21), and two M10 Nylon
Locknuts(71).
Attach the Top Frame (8) to the Rear Upright (7)
with two M1O x 70mm Bolts(58), the 70mm
Space Support Plate (56), and an M10 Nylon
Locknut (71).
0o not tighten the M10 Nylon Looknuts (71)
yet.
7.
Attach the Seat Frame (5) to the Front Upright (6)
with two M10 x 70ram Bolts (58), two M10
Washers (26), and two M10 Nylon Locknuts (71).
Attach the Seat Frame (5) to the Seat Upright
(73) with two M10 x 70ram Bolts (58), two M10
Washers (26), and two M10 Nylon Locknuts (71).
Tighten the M10 Nylon Locknuts (71) used In
steps 2-7.
8.
Press a 50mm Square Inner Cap (22) into the
Butterfly Frame (9).
Lubricatethe M10 x 75mm Bolt (60) with grease.
Attach the Butterfly Frame (9) to the Top Frame
(8) with the Bolt and an M10 Nylon Locknut (71).
Do not overtlghten the Locknut; the Butterlly
Frame must be able to pivot easily.
6
58
• 0 " i
22
..-'_
6O
7