Maintenance And Trouble-Shooting - Weslo PURSUIT 618s User Manual

MAINTENANCE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the exercise cycle
regularly. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the batteries when storing the
exercise cycle.
HOW TO TIGHTEN THE CRANK
If the arms of the Crank (33) become loose, they
should be tightened in order to prevent excessive
wear. Loosen the crank nut on the left arm of the
Crank. Place the end of a standard screwdriver in one
of the slots in
the slotted
crank nut.
__Slott
Lightly tap
the screw-
driver with a ed
hammer to Cran _ Crank Nut
turn the slot- Nut __,__
ted crank nut
counterclock-
wise until the
33
%//%_. %
arms are no r_J
longer loose.
Do not over-
tighten the slotted crank nut. When the slotted
crank nut is properly tightened, retighten the crank nut.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. To replace the batteries, see
assembly step 2 on page 6. In addition, make sure
that the console wire is connected to the reed switch
wire.
HOW TO ADJUST THE PEDAL STRAPS
To adjust the Right
Pedal Strap (4), first
pull the Pedal Strap
off the tab on the
pedal. Align a differ-
ent hole in the
Pedal Strap with the
tab. Press the Pedal
Strap back onto the
tab. Adjust the Left
Pedal Strap (not
shown) in the same manner.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (1) must be removed.
Using an adjustable wrench, turn the Left Pedal (28)
34
33
28
26
clockwise and remove it from the Crank (33). Remove
the two M4 x 12mm Screws (26) and the three M4 x
38mm Self-tapping Screws (34) from the Left Side
Shield. Next, lift the Side Shield Cover (40) off the
Side Shields. Grasp both Side Shields at the top and
gently pull them apart. Make sure that the arm of the
Crank is in the position shown in the drawing above.
Carefully slide the Left Side Shield forward off the arm
of the Crank and remove it.
Next, locate the
Reed Switch (50).
Turn the Crank (33) 9
until the Magnet (51)
is aligned with the
Reed Switch.
Loosen but do not
remove the M4 x
16mm Self-tapping
Screw (9). Slide the
Reed Switch slightly
closer to or away
from the Magnet. Retighten the Screw. Turn the Crank
for a moment. Repeat until the console displays cor-
rect feedback. When the Reed Switch is correctly
adjusted, reattach the left side shield and the pedal.
12