Assembly - Weslo PURSUIT 618s User Manual

ASSEMBLY
Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the
packing materials until assembly is completed,
Assembly requires the included allen wrench _ , a phillips screwdriver ¢_ -J_ and two
adjustable wrenches __
m
1. Identify the Front Stabilizer (17), which has Wheels
(25) on the ends.
Hold the Front Stabilizer (17) against the saddle on
the front of the Frame (15). Make sure that the
Front Stabilizer is turned so the square holes are
facing away from the saddle. Attach the Front
Stabilizer with two M8 x 65mm Carriage Bolts (30)
and two M8 Nylon Locknuts (21).
Attach the Rear Stabilizer (not shown) to the rear of
the Frame (15) in the same manner.
2,
The Console (7) requires two "AA" batteries (not
included). Alkaline batteries are recommended.
Remove the Battery Cover (59), located on the
underside of the Console. Press two batteries into
the battery compartment Make sure that the bat-
teries are turned so the negative ends (marked
"-") are touching the springs in the battery com-
partment. Reattach the Battery Cover,
Carefully slide the Handlebar Post (14) onto the
Frame (15). Be careful to avoid pinching the
wires inside the Handlebar Post, Attach the
Handlebar Post with three M10 x 25mm Button
Screws (8) and three M10 Split Washers (41).
Refer to the inset drawing. Thread the console wire
down through the round hole in the console plate,
into the hole in the right side of the Handlebar Post
(14), and out the top of the Handlebar Post.
Connect the console wire to the Reed Switch Wire
(50). Attach the Console (7) to the Handlebar Post
(14) by sliding the Console onto the indicated tab.
Insert any excess console wire and Reed Switch
Wire into the Handlebar Post.
Attach the Knob Housing (12) to the Handlebar Post
(14) with an M4 x 16mm Self-tapping Screw (9).
30
25
17
25
15 21
Console
Wire
Console
Plate
41
6