Brother Entrepreneur Pro PR-1000 Installation Manual page 8

If the following error message appears
• Verify that the CD key and internal machine
identification number (No.) have been entered
correctly, and then repeat the procedure from step
c
. To close the message, click OK.
• The CD Key is valid for use with only one
designated internal machine identification number
(No.).
Check that the CD key has been entered correctly,
and then repeat the procedure from step
close the message, click OK.
• Check the Internet connection, and then click
Certify again. To close the message, click OK.
j
Write down the 8-digit Certification Key that
appears.
Note
• After upgrading the embroidery machine to KIT
the Certification Key must be entered in the
embroidery machine Settings screen.
6
k
Click Finish.
If the latest program has already been
installed in the machine
Skip the steps
procedure from step
l
While pressing the "Automatic Threading"
button, turn the embroidery machine on.
c
. To
Use USB media or a computer to install the upgrade
application for KIT I on the embroidery machine.
If USB media is to be used, refer to the instructions that
follow.
If a computer is to be used, refer to page 8.
When using USB media to perform the installation
m
Copy Upgrade application for KIT I
(************.upf) from the CD-ROM to the
USB media.
If you downloaded the latest program in step
f
, copy the file (************.upf) from your
computer.
Note
• Upgrade application data is contained in the "PR-
1000_PR1000e" folder.
• Copy only the Upgrade application for KIT I to the
USB media; no other files should be on the media.
I
,
l q
to , and then start the
r
.