Casio Exilim EX-V8 User Manual page 88

The wrong date and time are
displayed,
The messages on the display
are in the wrong language.
I can't transfer images over a
USB connection.
The date and time setting is wrong, Set the correct date and time (page 210).
The wrong display language is selected, Change the display language setting (page 214).
Display language setting
screen appears when the
camera is turned on,
1) The USB cable may not be connected securely. Check all connections.
2) If your computer is running Windows 98SE or 98, the USB driver may not be installed. Install the USB
driver (page 234), which you can download from the official EXILIM Website at http://www.exilim,com/
3) If your computer is running Windows 98SE or 98, the USB driver may be installed incorrectly, Reinstall
the USB driver correctly (page 234).
4) The wrong USB communication protocol may be selected. Select the correct USB communication
protocol in accordance with the type of device you are connecting (page 216),
5) If the camera is not turned on, turn it on.
1) You did not configure initial settings after purchasing the camera or the battery may have been left with
a dead battery, Check the camera setup (pages 11,210),
2) It may be a problem with the camera's built-in memory management area, If this is the case, perform the
reset operation to initialize the camera's setup (page 155). After that, configure each setting. If the
language selection screen does not re-appear when you turn the camera on, it means that the camera's
built-in memory management area has been restored,
If the same message appears after you turn power back on, contact your retailer or a CASIO service
center,
APPENDIX
279