Send(List) Examples; Sending Matrix Data With The Cfx-9800G Link Mode - Casio CFX-9850G User Manual

Chapter 3: Commands and Programming
the list. When using the Send(List) command, you should specify the list that
contains the commands by replacing "List" with a CFX-9850G List variable
(List 1 through List 6).
To input the "Send(" command on the CFX-9850G
1. In the CFX-9850G PRGM EDIT Mode, press [SHIFT] [PRGM] [F6] (g)
2. Press [OPTN] [F1] (LIST) [F1] (List) [1] to input List 1. You can input any

Send(List) Examples

The following shows two samples using the Send(List) command.
P.36 For full details about using commands to control the data analyzer, see "Com-
mand Reference".

Sending Matrix Data with the CFX-9800G LINK Mode

Use the CFX-9800G calculator's LINK Mode to send matrix data to the data
analyzer. Note that the matrix you use for this purpose must have only one
column.
To send matrix data from the CFX-9800G
1. Check to make sure that the data analyzer and the CFX-9800G are con-
P.13
2. Turn on the data analyzer.
3. On the CFX-9800G, press [B] (LINK) to enter the Data Communication
4. Press [F1] (TRN) [!] [!] [!] [!] [EXE] [F2] (ONE) to display all of the
5. Use ["] and [!] to scroll through the data and select the matrix that con-
6. Press [EXE] to send the data.
• The data analyzer receives the matrix data and executes setup commands
28
• Sending a new setup command (Command 1 or Command 3) clears all
previously sampled data from data analyzer memory.
[F4] (I/O) [F3] (Send) to input the Send( command at the current cursor
position.
value from 1 through 6 in place of [1] to specify List 1 through 6.
{1,2,2,1} " List 2
Send(List 2)
{3,0.2,100} " List 3
Send(List 3)
• Sending a new setup command (Command 1 or Command 3) clears all
previously sampled data from data analyzer memory.
nected properly.
Mode.
matrix data currently stored in memory.
tains the command you want to send.
accordingly.