Casio CFX-9850G User Manual page 37

Chapter 3: Commands and Programming
P.68
P.68
Post-Processing Parameter
This parameter specifies the type of post-processing to be applied to sam-
pled data. The initial default for this parameter is 0.
Derivative and statistical post-processing are performed using values pro-
duced by conversion equations.
Stat Samples Parameter
This parameter is used during statistical post-processing to specify how many
samples should be used for post-processing. This parameter is valid only
when 3 (statistics) is specified for the post-processing parameter. A value
from 2 to 512 can be specified for this parameter, and The initial default for
this parameter is 10.
38
1 Auto-ID
If Auto-ID is not activated, voltage in the range 0 to 5V is used.
2 Voltage (±10V)
3 Current (±10A)
Based on Vin input, 1V = 1A.
4 Resistance (1k% to 100k%)
5 Period (0.000004 to 50 seconds)
See "Period and Frequency Measurement" in Appendix A.
6 Frequency (0.02Hz to 250kHz)
See "Period and Frequency Measurement" in Appendix A.
7 Temperature (–20°C to 130°C)
8 Temperature (–4°F to 266°F)
9 Light (100 to 999)
10 Voltage (0 to 5V)
0 None (no processing)
d/dt
(first derivative)
1
d/dt
Only the
processing is selected.
d/dt d
2 and
d/dt
The and
of post-processing is selected.
3 Statistics (mean, standard deviation, minimum, maximum)
• Post-processing is disabled whenever the number of samples parameter
of Command 3 (SAMPLING/TRIGGER SETUP) is –1, which specifies
real-time display of sampled data.
indicator is on the display when this type of post-
2 2
/dt
(first derivative and second derivative)
2 2
d /dt
indicators are on the display when this type