GE MultiLink Quick Start Manual page 36

QUICKSTART GUIDE
32
In this example the switch that the computer is connected to is a Multilink ML1600.
The instruction manual for the MultiLink provides a list of all instructions. A valid IP address
and subnet mask can be programmed into the switch using the IP config command as
follows:
Type ipconfig ip=, then enter the IP address (in our example we will
use a unique address between 3.94.244.1 and 3.94.244.254),
followed by a space.
Type mask=
Enter the mask (in our example system we would use 255.255.252.0).
If a default gateway is also required enter a space and type dgw=
Enter the ip address of the gateway.
MULTILINK ETHERNET COMMUNICATIONS SWITCH – QUICKSTART GUIDE